How to Guide

Measure and establish the

boundaries of the slab using a

measuring tape, spikes and string.

Excavate the area to remove grass and debris. Ensure that the

excavated area is pitched in the direction water should run, away from

any building.

Add forms using 2x4s and ensure they are level. Nail the forms

together and remove the string.

Lay a gravel base (1 to 2 inches in depth) using Sakrete All Purpose

Gravel. This will help with any water ow or substrate movement and

prevent the concrete from buckling.

PREPARATION

The Pro’s Choice Since 1936

Constructing a concrete slab

using Sakrete Concrete Mixes

(High Strength, Maximizer, Fast Setting, Crack Resistant or 5000 Plus)

Project how-to guide

Sakrete.com • 866-725-7383

PAGE 1
Constructing a concrete slab using Sakrete Concrete Mixes (High Strength, Maximizer, Fast Setting, Crack Resistant or 5000 Plus) Project how-to guide The Pro’s Choice Since 1936 PREPARATION Measure and establish the boundaries of the slab using a measuring tape, spikes and string. Excavate the area to remove grass and debris. Ensure that the excavated area is pitched in the direction water should run, away from any building. Add forms using 2x4s and ensure they are level.
PAGE 2
Constructing a concrete slab using Sakrete Concrete Mixes (High Strength, Maximizer, Fast Setting, Crack Resistant or 5000 Plus) Project how-to guide The Pro’s Choice Since 1936 APPLICATION Add water as needed, 3.5 to 4 quarts of water depending on the type of concrete mix. Concrete can be mixed in a wheelbarrow, mortar pan or a mixer. Add enough water so mixture moves freely and does not ball up. A mixer is an inexpensive rental item and will make the project easier.
PAGE 3
Constructing a concrete slab using Sakrete Concrete Mixes (High Strength, Maximizer, Fast Setting, Crack Resistant or 5000 Plus) Project how-to guide The Pro’s Choice Since 1936 FINISHING Once the wet sheen of the concrete has disappeared, apply the final trowel coat. NOTE: The sheen will reappear as the surface is troweled. Using an ordinary broom, lay it on the surface of the slab and gently drag it across the surface to create a textured, non-skid finish.