How to Guide

MIX PRODUCT ACCORDING TO

DIRECTIONS ON BAG.

Product can be mixed in a wheelbarrow,

mortar pan or mixer.

NOTE: Follow water requirements on bag

to ensure mortar has adequate strength to

hold the stones and is color consistent.

Attach metal lath once the moisture barrier is in place.

Apply a scratch coat over the metal lath. The mortar should be applied

approximately 1/2 inch thick, ensuring the lath is completely covered

and in place at least 12 hours before setting stone.

Install a moisture barrier prior to installing stone veneer.

NOTE: Stone Veneer can be installed over concrete, block or

wood surfaces.

PREPARATION

APPLICATION

The Pro’s Choice Since 1936

installing stone veneer

using Stone Veneer Mortar

Project how-to guide

Sakrete.com • 866-725-7383

PAGE 1
installing stone veneer using Stone Veneer Mortar Project how-to guide The Pro’s Choice Since 1936 PREPARATION MIX PRODUCT ACCORDING TO DIRECTIONS ON BAG. Product can be mixed in a wheelbarrow, mortar pan or mixer. NOTE: Follow water requirements on bag to ensure mortar has adequate strength to hold the stones and is color consistent. APPLICATION Install a moisture barrier prior to installing stone veneer. NOTE: Stone Veneer can be installed over concrete, block or wood surfaces.
PAGE 2
installing stone veneer using Stone Veneer Mortar Project how-to guide The Pro’s Choice Since 1936 FINISHING Place the stones on the ground and arrange according to preference before setting them. Stones can be reshapped using a chipping hammer. Apply mortar to the back of the stone and begin setting stones at the lowest point on the wall and work up. It is best to begin at the corner. Use the trowel to create a space in the center of the mortar to help with adhesion.