Installation Guide

Prepare the concrete surface by pressure washing.

It is important that the surface is clean and free of

dirt and build up.

PREPARATION

Once the concrete surface has been thoroughly cleaned and has had adequate time to dry, your chosen

stencil can be layed in the desired design. Tape the edges of the stencil to secure it into place.

Prepare the spray gun assembly in advance of any stenciling project.

(view our spray gun assembly instructional video at www.sakrete.com)

Mixing Process

1. Begin the mixing process by adding the water requirements for the Sakrete Flo-Coat to a 5-gallon bucket.

2. Add the selected cement color additive to the water and briey mix the water and color additive together using a drill.

3. Add in the Flo-Coat Resurfacer and mix for several minutes using the drill. The mix should be uid and free of lumps.

4. Pour the colored Flo-Coat Resurfacer into the hopper of the spray gun assembly.

The Pro’s Choice Since 1936

Stenciling concrete

using Flo-Coat

Resurfacer and Cement Color

Project how-to guide

Sakrete.com • 866-725-7383

PAGE 1
Stenciling concrete using Flo-Coat® Resurfacer and Cement Color Project how-to guide The Pro’s Choice Since 1936 PREPARATION Prepare the concrete surface by pressure washing. It is important that the surface is clean and free of dirt and build up. Prepare the spray gun assembly in advance of any stenciling project. (view our spray gun assembly instructional video at www.sakrete.
PAGE 2
stenciling concrete using Flo-Coat Resurfacer & Cement Color Project how-to guide The Pro’s Choice Since 1936 APPLICATION Begin spraying the stenciled area, using cardboard to catch any overspraying that occurs. Spray in circular patterns. Don’t try and cover the area all at one time. Heavy spraying can result in product running under the stencil. Once the stenciled area has been adequately sprayed, remove the stencil from the area. DO NOT allow the Flo-Coat Recurfacer to dry with the stencil in place.