Owner's Manual

Archetype Assembly Instructions
Threaded
Rod
Nut
Metal
Washer
Rubber
Washer
Basic Assembly
The Archetype shelf construction consists of a nut, metal washer and
neoprene rubber washer sandwiching the shelf material on each side.
Leveling
Loosen top nuts then level shelf by adjusting
the position of the lower nuts. Check for
level on front and side (using level
provided with rack). Then tighten top nuts.
Please Note
As part of its durable finish, metal parts are coated with a light oil.
Please protect carpet and fabric from metal parts during assembly.
1. Put nuts on rods
Put two hex nuts on each of the
four rods.
2. Install bottom shelf
Attach shelf to underside of
lower nuts. Be sure to remem-
ber the metal and rubber
washers as illustrated at top of
page. Adjust bottom shelf to
desired height and level using
procedure described at top of
page. Add rubber feet.
3. Install shelves
Lower the second shelf atop
the four hex nuts, metal and
rubber washers. Add rubber
and metal washers and the hex
nuts to the top of the shelf.
Level the shelf and firmly
secure it using the wrench.
4. Adding top nuts
Place a hex nut near the top of
each rod and add metal and
rubber washers.
Note: Assembly is shown
with the A3, if you have a
larger unit repeat step three
as necessary.
5. Install top shelf
Position the top shelf so that the
top of the rods are flush with
the top of the shelf. Level the
shelf by adjusting the lower
nuts, then add the closed-end
top fasteners until finger tight.
Secure by tightening bottom
nuts with wrench.
Limited Warranty
For five full years Salamander Designs Ltd will repair
or replace, at our option, any product defective in
materials or craftsmanship. Salamander Designs Ltd.
will not be responsible for any damage to or destruction of other
equipment consequential to our equipment failure. Defective
product must be given Return Authorization and is to be returned
to the factory prepaid, in the original carton and packing material.
Any damage incurred in a shipment not in original packaging
shall be the responsibility of the owner. Warranty repairs will be
returned prepaid, via UPS within the continental U.S.A. only.
Salamander Designs Ltd. 800-535-5659