Assembly Instructions

Afx socket screw (300-465)
into second hole from top
on inside of posts. Place
rubber covers (303-375)
on screw heads.
TIP:
You may need to wiggle the rear panel to set it into place.
4 Install Door Pulls
5 Rear Panels
Fine Tuning/Tips
Secure pulls with screws
using a Phillips screwdriver.
Locate the rear post channels.
Lead one end of the rear panel into a
post channel.
Compress the rear panel rmly into
the opposing post channel.
Aligning Doors
Innitely Adjustable Shelves
Assemble loosely as shown.
Insert into post channel and slide to desired height.
Level shelf by adjusting shelf peg positions and
tighten screw using hex key.
Note: Drop-in nut must make a 1/4 turn in post.
Main Adjustment (Side to Side and Up/Down)
Adjustment is made by turning screw (A) in and out.
Dismount Hinge from Hinge Plate
With one hand holding the door open, pull
back on the hinge quick-release lever (B).
Follow these instructions if you wish to adjust your doors.
Speaker Grill Assembly
(Applicable Models Only)
Socket Screw 3/4’’
(300-465)
Shelf Peg
Drop-In Nut
(300-565)
Attach the two brackets (303-370) using the wafer-
head screws (300-115) to backside of speaker grill.
Note the “UP” arrow.
Speaker Grille Hardware Bag - PHK-2085
Media Drawer Assembly
Set drawer liner (303-555)
on bottom of tray.
Place media organizer
(303-310).
Note: Horizontal grooves.
Socket Screw
300-465
Bracket
303-370
Waferhead Screw
300-115
Rubber Cover
303-375
Place grill pads (303-545) ush to corner edges.
Grill Pad
303-545
Hang speaker grill on brackets.
NOTE: Remove by lifting up and out.
Media Organizer
Drawer Liner
Door Front
Adjust the tops of the doors to be
parallel to the top of the cabinet.
A
A
B
C
A
B
C
D
A
B
A
A
B
1
2
B