Installation manual

TORQUE

ITEM OPERATION

Retrieve the air intake snorkel (with attached lid) and slide the throttle

body portion onto the throttle body. Use a flat blade screwdriver to

tighten the clamp.

Secure the air box lid to the air box. Slide the lid over the tabs in the air

box and press to the lid down onto the air box. Make sure both clasps

on the air box (facing the driver side fender) are fully engaged.

Use a tension clamp tool to open up the clamp securing the breather

tube to the intake snorkel. Slide the tube back into the intake snorkel

and re-secure the clamp.

Re-connect the MAF pigtail to the sensor. Press the MAF connector

onto the sensor. Slide the red locking tab on the connector towards the

sensor to lock the connector in place.

Press the end of the passenger side vent tube onto the intake snorkel

fitting until it "clicks" into place.

ITEM PART NUMBER QTY. DESCRIPTION

TORQUE

NOTES:

PROCESS PAGE

INSTALL AIR INTAKE SNORKEL

2010 MODELS