Installation manual

TORQUE

ITEM OPERATION

Set the modified air box assembly into the inner fender by lining up the

two studs w/ grommets with the two holes in the inner fender.

Line up the air box assembly mounting hole with the J-clip on the inner

fender well and re-install the 10mm air box bolt. With a torque wrench,

tighten the bolt to 71 Lb-in +/- 10.6 Lb-in

Slip the air inlet duct (A) over the lip of the throttle body. Tighten the

8mm clamp attached to the inlet tube to 27 Lb-in +/- 4 Lb-in

with a

torque wrench.

Slip the other end of the air inlet duct (B) over the lip of the air box

assembly. With a torque wrench, tighten the attached 8mm clamp to

27 Lb-in +/- 4 Lb-in

Reconnect the crankcase vent tube to the passenger side of the air inlet

duct, just in front of the throttle body. Press the tube onto the vent fitting

until it locks into place.

ITEM PART NUMBER QTY. DESCRIPTION

06-1602-C13094 1

Air Inlet Duct

TORQUE

NOTES:

71 +/- 10.6 Lb-in

27 +/- 4 Lb-in

PROCESS PAGE

INSTALL AIR BOX AND SNORKEL