Installation manual

TORQUE

ITEM OPERATION

Locate the windshield washer sprayer hose (located underneath the

hood liner) and disconnect the line from the sprayers. There is a rubber

T-fitting on the RH side (passenger) and an elbow on the LH side

(driver). Then remove the sprayers.

Remove the two clips holding the windshield washer sprayer line to the

hood with a panel puller. The clips are located near the RH side

(passenger) hood hinge. Once the sprayer line is fully disconnected

from the hood, set the hose aside out of the way.

While another person helps hold the hood, carefully remove the four

10mm bolts (2 per side) that attach the hood to the hinge. Once the

hood is free of the hinges, carefully set the hood aside where it cannot

get damaged.

NOTICE: The hood liner may need to be partially removed to reach

the sprayer T-fittings. To remove the tree clips, use a panel puller.

ITEM PART NUMBER QTY. DESCRIPTION

TORQUE

NOTES:

PROCESS PAGE

REMOVE HOOD