Installation manual

TORQUE

ITEM OPERATION

Disconnect the throttle position sensor electrical connector by sliding the

red shield on the connector towards the front of the car. Push down on

the now exposed tab, and pull the connector towards the front of the

vehicle to remove.

Disconnect the electronic throttle control electrical connector by pulling

the red locking tab outward. Pull the connector outward.

Remove the 2 studded bolts at the top of the throttle body and remove

the 2 nuts at the bottom. Remove the throttle body.

Once the throttle body is removed, remove the orange gasket from the

intake manifold. Both the gasket and throttle body will be re-used.

ITEM PART NUMBER QTY. DESCRIPTION

TORQUE

NOTES:

PROCESS PAGE

REMOVE THROTTLE BODY