Installation manual

TORQUE
ITEM OPERATION
Before removing the water crossover, plug the weep hole at the back of
the engine block. This will contain the coolant on the top of the block for
easier clean up and less mess.
Disengage the locking clip on the heater return and supply hose and
disconnect the hose from the back of the water crossover.
Remove the two remaining 10mm bolts retaining the water crossover to
the engine (the other two bolts were shared with the intake manifold).
Remove the water crossover.
Save the round blue gasket found on the underside of the water
crossover. It will be used on the new crossover.
NOTICE:
For 2007 to 2009 vehicles, see below.
After the water crossover is removed, cover the exposed head ports with
masking tape.
NOTICE: If your vehicle is a 2007 to
2009, you will also need to save the
other water crossover gasket (pictured
next to this notice).
ITEM PART NUMBER QTY. DESCRIPTION
TORQUE
NOTES:
PROCESS PAGE
REMOVE WATER CROSSOVER
20
20
30
10
40
50
10
20
30
40
50
2007 to 2009 WATER CROSSOVER SHOWN -
2005 to 2006 CROSSOVERS ARE SIMILAR