Installation manual

f
TORQUE
ITEM OPERATION
Proceed to the alternator end of the harness. With side cutters, remove
the small zip tie holding the signal wire to the positive cable wire. The
zip tie is located near the ring terminal boot.
Carefully remove the 2 white tree clips from the harness, by cutting the
electric tape holding them in place with a razor. Remove any excess
electric tape from the harness.
With a razor, carefully cut away any electric tape or label holding the
convoluted tubing together. Peel back the convoluted tubing to expose
the red positive cable and the signal harness. Carefully cut the electric
tape holding the signal harness to the positive cable. Remove the signal
harness.
Line up the alternator connector (signal harness) even with the bottom o
the ring terminal as shown. Once the signal harness is in its new
position, electric tape the signal harness to the positive cable.
ITEM PART NUMBER QTY. DESCRIPTION
TORQUE
NOTES:
PROCESS PAGE
MODIFY ALTERNATOR HARNESS
2009 VEHICLES
33
20
30
10
40
C
REMOVE
20
30
SIGNAL HARNESS
POSITIVE CABLE
POSITION THE SIGNAL
HARNESS CONNECTOR
EVEN WITH THE BOTTOM
OF THE RING TERMINAL
40
10