Installation manual

TORQUE

ITEM OPERATION

Slide the front wheels onto the hub on each side, and hand start each

lug nut to help hold the wheel from sliding off of the hub.

Seat each lug nut to the wheel (lightly tightened). Do not completely

torque the lug nuts, but snug them up so that the wheel is held firmly to

the hub.

Verify all lug nuts and the wheels are firmly seated into place, and slowly

lower the front of the vehicle onto the ground.

NOTE: When removing items like jack stands from under an

elevated vehicle, use EXTREME CAUTION

. Any time a vehicle is

elevated off of the ground it may be unstable and have the

potential to fall. Refer to the jack stand or floor jack owners

manual for proper equipment operation and safety measures.

Make sure the parking brake is still set (to help prevent the vehicle from

rolling) With a torque wrench and a 13/16" socket, torque the 5 lug nuts

on each wheel (10 total) to 100 Lb-ft +/- 15 Lb-ft.

Make sure to torque

each lug nut in a criss-cross pattern like the one shown (to evenly seat

and secure the wheel).

ITEM PART NUMBER QTY. DESCRIPTION

TORQUE

NOTES:

100 +/- 15 Lb-ft

PROCESS PAGE

INSTALL RH WHEEL