Installation manual

TORQUE

ITEM OPERATION

Retrieve the supercharger assembly (A).

With a large zip tie (B), fasten the bypass actuator arm up into the

bypass valve.

2005 to 2008 MODEL:

Inspect the 8 gaskets that were removed from

the stock intake manifold on Page 16. Install each gasket into the

supercharger (make sure the gaskets are fully seated).

NOTICE: If the gaskets show signs of wear or deterioration, they

will need to be replaced.

2009 MODEL:

This kit comes with 8 new intake manifold gaskets (C)

(due to the different design of the '09 manifold). Install each gasket into

the supercharger (make sure the gaskets are fully seated).

Remove the bypass stop screw from the supercharger assembly.

NOTICE: DO NOT change the position of the nut on the bypass

screw. It is a pre-determined stop for the bypass valve arm.

Do a last minute check of the assembly. Verify that the fuel rail with

correct injectors are installed and that all 8 manifold gaskets are in place

and properly seated ( OPERATION 30

Slowly lower the supercharger assembly onto the top of the engine. Lift

up on the front of the assembly as it is lowered to keep the nose

assembly from getting damaged.

Re-install the bypass stop screw until the nut attached to the screw

contacts the assembly casting. Then cut the large zip tie.

ITEM PART NUMBER QTY. DESCRIPTION

00-1607-B19330 1 Supercharger Assy, Series VI.5

069-703

14" Zip Tie

00-1607-C14616*

Gasket, Intake Manifold To Head

TORQUE

NOTES:

PROCESS

PAGE

INSTALL SUPERCHARGER