Operation Manual

RADIO
EN-6
ENGLISH
MANUAL TUNING
1. Press
BAND button to select desired BAND (AM or FM).
2. Tune to the required station by pressing the or button.
3. Adujst volume control to the desired volume level.
AUTO TUNING
1. Press
BAND button to select desired band (AM or FM).
2. Press and hold the or button for 1 - 2 seconds and then release.
3. The unit will start scanning automatically and stops when a radio station is reached.
4. Repeat steps
2 & 3 until a desired radio station is reached.
5. Adjust volume control to a desired volume level.
PRESET STATIONS BY REMOTE HANDSET
You can store up to a total of 40 radio stations in the memory (30-FM / 10-AM).
1. Set to TUNER mode.
2. Tu
ne to the desired radio station by "MANUAL" or "AUTO" tuning methods.
3. Press
MEMORY/CLOCK button to enable programming state.
4. Press
PRE button to select the desired station memory for storage.
5. Press
MEMORY/CLOCK button again to confirm the setting.
6. Repeat steps 2 to 5 to store other stations.
7. Press
PRE button to reload the preset stations in order.
8. To return to normal tuner mode, leave the keys alone.
FM & FM-STEREO RECEPTION
• Press the
MONO
/ST.
on remote handset to select MONO or STEREO
reception mode.
HINTS FOR BEST RECEPTION:
AM: The receiver has a built-in AM ferrite antenna. If the AM reception is weak, rotate or reposition the
unit. This usually improves the AM reception.
FM: Attached FM wire antenna plugged in at the rear of the unit should be fully unwound and extended
its full length for best reception.
LISTENING TO THE RADIO