Instructions / Assembly

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2012 Salsbury Industries. All rights reserved. 2/17/12
Designer Gear Lockers – 30000 Series
Installation Instructions
Thank you for selecting the 30000 Designer Gear Lockers. We are confident that the quality and construction of the lockers will prove to be a good
investment. These instructions are intended to assist you in a typical wall-anchored or back-to-back locker installation. Individual job conditions will
dictate the type of fasteners and whether the lockers must be anchored to the wall, the floor, or both.
The 30000 Designer Gear Lockers require minimal assembly. The basic
lockers are factory assembled. It may be necessary to attach the lockers
to each other, the optional side panels to the exposed sides of the
lockers, and the lockers to a wall.
Hardware Supplied with Each Locker
1. (1) Metal wall strap with three holes to attach locker to wall or back-to-
back. Bend the strap to tie locker to wall as shown in illustration.
2. (3) #10 x 5/8” long hex-head sheet metal screws to attach strap to top
of lockers back-to-back or between locker and wall.
3. (2) #10 x 1-3/8” long hex-head machine screws to fasten lockers
together side-by-side. Mating tee-nuts are pre-installed in locker walls.
4. (2) 1-1/4” long drywall screws to attach side panel to locker.
5. (2) Number plates.
Installation Instructions
1. Lockers should be set in place and leveled. The rear edge of the
base should touch the wall or the other base if lockers are installed back-
to-back. There will be a 5/8” air space between the rear surface of the
locker body and the wall or a 1-1/4” air space between the rear surfaces
of the back-to-back lockers.
2. If the back of the locker is against a wall, bend the metal strap as
shown in the illustration. The metal straps will be installed in Step 5
below.
Leave the metal strap flat for fastening lockers back-to-back. There will
be a 1-1/4” ventilation space between the backs of the locker bodies if
lockers are back-to-back and side panels are being installed. The metal
straps will be installed in Step 5 below.
3. Bolt multiple lockers together through the two unused holes near the
front edge of the locker sides. The same holes are used to attach the
optional finished side panels.
4. Attach the optional finished side panels flush with the front of the
locker body, allowing the excess width to cover the 5/8” rear air space.
5. Once the lockers are plumb and level, attach the bent or flat metal
straps to the top of the lockers and to the wall or other lockers as
required.
6. Peel backing from number plates, align, and press into recess.
Installation Illustration

Summary of content (2 pages)