inst regency cbu

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Ph: 1-800-624-5269 Int’l Ph: 323-846-6700
Fx: 1-800-624-5299 Int’l Fx: 323-846-6800
www.mailboxes.com [e-mail]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 06, 11/13/2015)
Regency
®
Decorative CBU’s
Models 3308R, 3312R, 3316R, & 3313R
Installation Instructions
U.S.P.S. APPROVED
Thank you for your purchase of Regency
®
Decorative CBU’s manufactured by Salsbury Industries. We are confident that you will find them to be an
attractive addition to commercial and residential developments. Regency
®
Decorative CBU’s include a cluster box unit, a CBU pedestal, a
decorative CBU top and a decorative pedestal cover. This first page instructs how to attach the decorative top to the CBU and the pedestal cover to
the pedestal. The remainder of this document provides the installation instructions for the cluster box unit as a whole.
Installation of Decorative Top
1. Fasten the ball finial to the decorative top from the underside of
the decorative top using two (2) M4x8 allen bolts.
2. Before placing the decorative top on to the CBU top, apply
thread lock to the four (4) M6x8 allen cone point set screws and
insert into the two (2) threaded holes on each side of the
decorative top.
3. Only turn the set screws until they are flush with the inside
surface of the decorative top so that the decorative top can be
placed on the CBU top.
4. Place the decorative top on to the CBU top. Be sure the logo on
the decorative top is positioned at the rear of the CBU. Tighten
the four (4) allen set screws evenly to secure the decorative top
to the CBU.
Decorative Top
Installation of Decorative Pedestal Covers
Note: The following instructions apply to both the short decorative
pedestal cover (# 3386) and the tall decorative pedestal cover (#
3396).
1. Place the pedestal gasket on the floor and wrap it around the
base of CBU unit’s pedestal.
2. Slide one half of the black plastic insect guard into the top of
either one of the decorative pedestal cover halves. Make sure
the locator tabs on the pedestal cover align with the slots on the
insect guard. Repeat on the other half of the pedestal cover.
3. Place one of the pedestal covers with guard installed into
position underneath the rear of the CBU and around the rear of
the pedestal.
4. Place the other pedestal cover with guard installed underneath
the front of the CBU and around the front of the pedestal.
5. Use four (4) M4x16 allen bolts, two (2) at the top and two (2) at
the bottom, to bolt the two (2) halves of the pedestal covers
together.
6. Thread four (4) M6x20 allen set screws, one at the top and one
at the bottom, on both the front and rear halves, into the
threaded holes to prevent the pedestal covers from moving.
Decorative Pedestal Covers