Installation Guide

Connector kit mounting hole
2 x 4 mounting hole
Page 4 of 7
Figure 3B – Top side of unit facing wall
Overtightening beyond initial contact with frame could hinder functionality. If overtightening occurs, simply back out each overtightened mounting screw.
Figure 3D – Top of unit
Figure 3C – Bottom side of unit facing wall
Figure 3E – Bottom of unit
STEP 3
Locate the 2x4 mounting holes on the inside corner of the parcel locker’s trim panel (see figure 3A to see the difference between the 2x4 mounting holes
and the connector kit mounting holes). Attach unit to the 2x4 wood framing (using the provided #8 square drive x 2” long wood screws) on the side, top
and bottom sections of the parcel locker unit (see figures 3B through 3E below).
Figure 3A
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes
no product assembly or installation liability. Copyright © 2015 Salsbury Industries. All rights reserved. (Rev. 11, 02/10/2017)
SALSBURY INDUSTRIES
1010 East 62nd Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone] Fax: [phone] Int’l Fax: [phone]
www.mailboxes.com [e-mail]