Installation Guide

4C Recessed Mounted Horizontal Mailboxes – Connector Kit
Rear Loading Unit Installation Instructions
Rough Opening
Height: See chart on page 6.
Width: To establish the size of the rough opening(s) in the wall(s) you
will be installing your mailbox configuration(s) into, calculate the overall
width of the total amount of units per wall installation; then subtract 3/4”
from the width grand total.
Example: (2) double-colum mailboxes are to be installed.
• Each unit is 31-1/8” wide x 2 units = 62-1/4”
• 62-1/4” - 3/4” = 61-1/2” required for rough opening.
STEP 1
Place the first unit into the rough opening (see figure 1). Open the master door panel(s) (see figures A-C below).
Hardware required for installation
-Connector #8 x 1/2” pan head self
tapping machine screws (provided
with each 4C Connector Kit)
-#8 square drive x 2” long
wood screws
(provided with mailbox)
Open the right master door panel until it
engages the locking position (see gure
A). While preventing the two front master
doors from fully closing together, remove
the cardboard strip divider.
To open the left master
door panel, insert a at-
head screwdriver into the
center locking hole (see
gure B) and push up to
pry the locking mechanism
upward; thus unlocking
the left master door panel.
Open the left master door
panel until it engages the
locking position.
If both master door panels
become fully closed, locate
the unlocking hole located
on the back of the unit.
Insert a at-head screw-
driver through one of the
unlocking holes (see gure
C) and push upward as
noted above to open the
master door panels.
Figure A
Figure B Figure C
Figure 1
Connector bar
corresponds to
unit height
Unlocking
hole on
rear of unit
Unlocking
hole on
front of unit
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes
no product assembly or installation liability. Copyright © 2015 Salsbury Industries. All rights reserved. (Rev. 20, 02/10/2017)
SALSBURY INDUSTRIES
1010 East 62nd Street, Los Angeles, CA 90001-1598
Phone: 800-624-5269 Int’l Phone: 323-846-6700 Fax: 800-624-5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering@mailboxes.com
Page 2 of 6