Instructions / Assembly

STEP 2
Open the master door panel(s) (see figures 2A and 2B below).
Page 3 of 7
Open the right master door panel until it engages the locking
position. While preventing the two front master doors from
fully closing together, remove the cardboard strip divider.
You can open the master door panel on single wide
units (see gure 2E) by lifting the lock bar screws
located on the side of the unit.
Open the carrier access door and locate the lock bar release
latch. Push the latch up to unlock both master door panels.
To open the left
master door panel,
insert a at-head
screwdriver into the
center locking hole
(see gure 2C) and
push up to pry the
locking mechanism
upward; thus unlock-
ing the left master
door panel. Open
the left master door
panel until it engages
the locking position.
If both master door
panels become
fully closed, locate
the unlocking hole
located on the back
of the unit. Insert a
at-head screwdriver
through one of the
unlocking holes (see
gure 2D) and push
upward as noted
above to open the
master door panels.
Rear Loading Units without Carrier Access Door
For Single-Wide Parcel Units without Carrier Access Door
Figure 2C
Figure 2D
Unlocking
hole on
rear of unit
Unlocking
hole on
front of unit
Figure 2E
Lift these two lock bar
screws upward to
open unit
Front Loading Units with Carrier Access Door
Lock bar release latch
Figure 2B
Figure 2A
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes
no product assembly or installation liability. Copyright © 2015 Salsbury Industries. All rights reserved. (Rev. 11, 02/10/2017)
SALSBURY INDUSTRIES
1010 East 62nd Street, Los Angeles, CA 90001-1598
Phone: 800-624-5269 Int’l Phone: 323-846-6700 Fax: 800-624-5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering@mailboxes.com