Installation Guide

Designer Roadside Mailboxes – 4325-D
Newspaper Holder Installation Instructions
U.S.P.S. APPROVED
Installing Newspaper Holder under Mailbox
Thank you for selecting Salsbury’s 4325-D designer roadside mailbox.
We are confident that the quality and construction of the mailbox will
prove to be a good investment.
This instruction sheet is for installing the 4325-D designer roadside
mailbox along with a 4315-D newspaper holder. Other installation
instructions are available for installing the mailbox on a standard post,
installing the mailbox on a deluxe post, installing the mailbox on
spreaders, or installing the post in a concrete footing.
When you install a curbside or roadside mailbox, make sure that it is
easily accessible to the mail carrier. By regulation it should be 41” to
45” from the ground or street surface up to the point of mail entry.
The door should be set back 6” to 8” from the front face of the curb or
the road edge. However, you should check with your local postmaster
to ensure that the mailbox is installed according to local regulations.
The mailbox is fastened to the newspaper holder with four (4) 5/16”
carriage bolts, washers, and nuts. The assembled mailbox and
newspaper holder is then fastened to the standard or deluxe post with
the four (4) 5/16” hex washer head bolts included with the post.
*Pricing shown above does not include shipping see BudgetMailboxes.com for complete pricing
Phone/Fax [phone].MAIL
www.BudgetMailboxes.com