Installation guide

Roadside Mailboxes - 4325
2-Wide Spreader Installation Instructions
U.S.P.S. APPROVED
Thank you for selecting Salsbury’s 4325 aluminum roadside mailbox. We are confident that the quality and construction of this product will provide
years of maintenance free use.
Installing Roadside Mailbox on a 2-Wide Spreader
This instruction sheet is for installing two (2) 4325 roadside
mailboxes on a 2-wide spreader on a bolt-mounted or in-ground
mounted standard pedestal (ordered separately). Other installation
instructions are available for installing the mailboxes on a 3-wide
spreader, directly to a pedestal, or in a wall or column, on a deluxe
post, or on a post in a concrete footing.
The mounting plate on the top of the pedestal has four tapped holes.
There are four 5/16” x 1/2” long hex washer head bolts provided with
the pedestal to fasten the spreader to the top of the pedestal. The
four black plastic caps may be used to cover the exposed heads of
the bolts.
The roadside mailboxes are each mounted to the spreader using four
5/16” x 1-1/2” long carriage bolts, one 1” thick aluminum spacer, flat
washers, and hex acorn nuts. Two of these kits are provided with the
spreader, one for each of the mailboxes.
Set a roadside mailbox in one of the positions on the spreader and
open the lower door. Install the carriage bolts through the mailbox
holes, through the spacers, and through the four holes in the
spreader. After assuring that the square shanks under the bolt
heads are securely in the square holes in the bottom of the mailbox,
attach the flat washers and hex acorn nuts to the bottom of the bolts.
Make sure the nuts are sufficiently tightened.
Repeat for the second 4325 roadside mailbox.
USPS Regulations
It is important to note that it is not the responsibility of mail carriers to
open mailboxes that are locked, accept keys for this purpose, or lock
mailboxes after delivery of the mail.
When you install a mailbox on a curbside or roadside, make sure that
it is easily accessible to the mail carrier. Customers are required to
contact the local post office before installing the mailbox to ensure its
correct placement and height at the street. Generally, mailboxes are
installed at a height of 41-45 inches from the road surface to the
inside floor of the point of mail entry and are set back 6-8 inches from
the front face of curb or road edge to the mailbox door.
Model 4325 Roadside Mailboxes
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone]
Fax: [phone] Int’l Fax: [phone]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved.