Installation Guide

Victorian Mailboxes – 4460
Surface Mounted Installation Instructions
Made of cast aluminum with a durable powder coat finish and a brass mail flap, 4460 Victorian surface mounted mailboxes will provide years of
maintenance free service.
Mounting the Victorian Mailbox to a Flat Wall
1. The installation fasteners are not provided due to the variation in
wall types to which the mailbox might be mounted. Select fasteners
and anchors appropriate for the type of wall.
2. Mounting access is provided by opening the mail flap and mail
access door.
3. Where possible, it is best to shield the mailbox from direct
weather conditions.
4. Contact your local U.S.P.S. office for the required height of the
mailbox on the wall.
5. For convenience, the mounting holes are key-holes. See
illustration.
6. Holding the mailbox aligned horizontally in the mounting position,
mark on the wall the position of the two mounting holes in the back
wall of the mailbox, behind the “LETTERS” flap.
7. Install the two fasteners, but do not tighten them. Hang the
mailbox loosely on the fasteners, and securely tighten them.
Cleaning
Interior & Painted Exterior – Using a soft cloth or sponge, clean the
interior and painted exterior of the mailbox with liquid soap, detergent
or diluted water-soluble household cleaners. Completely remove
residue of any cleaning products with water and thoroughly dry with a
clean cloth or paper towel.
Brass Mail Flap – The mail flap may be cleaned as indicated above.
DO NOT
use abrasive materials on polished brass surfaces.
4460 Victorian Mailbox
*Pricing shown above does not include shipping see BudgetMailboxes.com for complete pricing
Phone/Fax [phone].MAIL
www.BudgetMailboxes.com