Installation Guide

Townhouse Mailboxes – 4550
Installation Instructions
U.S.P.S. APPROVED
Installing on a Standard or Classic Mailbox Post
Thank you for selecting Salsbury’s 4550 townhouse mailbox. We are
confident that the quality and co
nstruction of the mailbox will prove to
be a good investment.
This instruction sheet is for installing the 4550 townhouse mailbox on
a Salsbury standard or classic m
ailbox post. Other installation
instructions are available for installing the mailbox on a decorative
post or on spreaders or mounting the post in a concrete footing.
When you install a curbside or roadside mailbox, make sure that it is
easily a
cce
ssible to the mail carrier. By regulation it should be 41” to
45” from the ground or street surface up to the inside floor of the
mailbox. The door should be set back 6” to 8” back from the front
face of the curb or the road edge. However, you should check with
your local postmaster to ensure that the mailbox is installed
according to local regulations.
The top of the Salsbury standard or classic mailbox post has four
tapped holes. There are four 5/1
6” bolts provided with the post to
attach the mailbox to the post. Open the front door of the mailbox
and install the four bolts through the four holes in the center of the
inside floor of the mailbox and into the four tapped holes in the top of
the standard or classic mailbox post.
Standard Post Mounting
Classic Post Mounting
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone]
Fax: [phone] Int’l Fax: [phone]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2008 Salsbury Industries. All rights reserved. (Rev. 03, 2/6/2008)