Installation Guide

ManualsBrandsSalsbury Industries ManualsHardwareVictorian In-Ground Mounted Decorative Mailbox Post in Black

Decorative Mailbox Posts – 4800 Series

Decorative Arm Post Installation Instructions

Installing Arm on a Decorative Post

Thank you for selecting Salsbury’s 4800 series decorative mailbox post. We are confident that the quality and construction of the post will prove to

be a good investment.

This assembly instruction is for the decorative post only, including

models 4825, 4826, 4835, 4836, 4845, and 4846.

See the installation instructions for the mailbox to install the mailbox

on the post. The hardware kit #4800-B for mounting the mailbox is

included with this post.

The decorative post should be mounted on the concrete pad or in the

ground before proceeding with assembly of the top plate and arm.

See separate instructions for the post mounting process.

The top plate and arm must be assembled to the post as shown in

the illustration. Install two 5/16”-18 x 1-1/4” long carriage bolts

through the two holes in the rear flange of the top plate into the upper

two tapped holes in the decorative post. Leave the bolts loose.

Position the arm so that the two studs in the front of the top plate

protrude through the holes in the front of the arm. Install two more

5/16”-18 x 1-1/4” long carriage bolts through the two holes in the

lower rear flange of the arm into the lower two tapped holes in the

decorative post. Also leave these bolts loose.

Install the two 1/4”–20 nuts on the studs at the front of the top plate

after ensuring that the two studs are aligned through the holes in the

front of the arm.

Securely tighten the four carriage bolts and the two hex nuts. Attach

the appropriate plastic cover caps to the four carriage bolts and the

two nuts.

Proceed to install the mailbox.

SALSBURY INDUSTRIES

1010 East 62

Street, Los Angeles, CA 90001-1598

Phone: 1-800-624-5269 Int’l Phone: 323-846-6700

Fax: 1-800-624-5299 Int’l Fax: 323-846-6800

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Summary of content (3 pages)

PAGE 1
Decorative Mailbox Posts – 4800 Series Decorative Arm Post Installation Instructions Installing Arm on a Decorative Post Thank you for selecting Salsbury’s 4800 series decorative mailbox post. We are confident that the quality and construction of the post will prove to be a good investment. This assembly instruction is for the decorative post only, including models 4825, 4826, 4835, 4836, 4845, and 4846. See the installation instructions for the mailbox to install the mailbox on the post.
PAGE 2
Decorative Mailbox Posts – 4800 Series Installation Instructions Installing Mailbox on a Decorative Post Thank you for selecting Salsbury’s decorative mailbox post. We are confident that the quality and construction of the post will prove to be a good investment. This instruction sheet is for installing the Salsbury 4850 mailbox on a Salsbury decorative mailbox post. When you install a curbside or rural mailbox, make sure that it is easily accessible to the mail carrier.
PAGE 3
Decorative Mailbox Posts – 4800 Series In-Ground Mounted Post Installation Instructions Installing the In-Ground Mounted Post for the Mailbox Into Concrete When you install a curbside or rural mailbox, make sure that it is easily accessible to the mail carrier. By regulation it should be 41” to 45” from the ground or street surface up to the inside floor of the mailbox. The door should be set back 6” to 8” back from the front face of the curb or the road edge.