Manual

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone]
Fax: [phone] Int’l Fax: [phone]
www.mailboxes.com [e-mail]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2013 Salsbury Industries. All rights reserved. (Rev. 02, 7/23/13)
Classic Mailbox Posts- 4890 Series
Mailbox Installation Instructions
U.S.P.S. APPROVED
Installing Mailboxes on a Classic Mailbox Post
Thank you for selecting Salsbury’s classic mailbox post.
This instruction sheet is for installing a mailbox on a Salsbury classic mailbox
post. Other installation instructions are available for mounting a newspaper
holder, assembling the post, and mounting the post in a concrete footing.
When you install a curbside or roadside mailbox, make sure that it is easily
accessible to the mail carrier. By regulation it should be 41” to 45” from the
ground or street surface up to the inside floor of the mailbox. The door
should be set back 6” to 8” back from the front face of the curb or the road
edge. However, you should check with your local postmaster to ensure that
the mailbox is installed according to local regulations.
4890 Classic Mailbox Post
All hardware to install the mailbox to the classic mailbox post is provided with
the post. To install the mailbox, set the mailbox on the classic mailbox post,
open the front door of the mailbox and install four (4) M8 x 1.25 x 20 mm
long pan head bolts through the four (4) square holes in the inside floor of
the mailbox and through the four (4) tapped holes on the top of the classic
mailbox post. Installation is now complete. Additional hardware provided is
not needed and may be discarded.
4891 Classic Mailbox Post
All hardware to install the mailbox to the one-sided classic mailbox post is
included with the mounting arm. To attach the mailbox, open the front door
of the mailbox and install four (4) 5/16”-18 x 1-3/4” long carriage bolts
through the four (4) square holes in the inside floor of the mailbox, through
four (4) 5/8” nylon spacers (thread onto bolt), and through the corresponding
holes in top of the mounting arm. Install 5/16” flat washers and 5/16”-18 hex
nuts on the ends of the four (4) bolts protruding below the bottom of the
mounting arm. Installation is now complete. Additional hardware provided is
not needed and may be discarded.
4892 Classic Mailbox Post
To install mailboxes to the 2-sided classic post, follow the instructions for the
“4891 Classic Mailbox Post” and attach an additional mailbox to the
mounting arm.