Installation Guide

Vented Lockers – 72000 Series
Double Tier Installation Instructions
Thank you for selecting Salsbury’s vented double tier lockers. We are confident that the quality and construction of the lockers will prove to be a
good investment. These instructions are intended to assist you in assembling the lockers. The lockers should then be placed in the installed
location and anchored to the floor, wall, or to both. Individual job conditions will dictate the type of anchor fasteners.
Preliminary Note
Please read the complete assembly instructions before attempting to
assemble the lockers. Check the materials to be sure that they are
correct for the job and that there is no damage.
Be careful to use the correct hardware. Use screw no. 1 all around
with screw heads out, except where noted. Lockers should be
assembled in groups as indicated in the order of the drawings.
The essential tools required for assembling the lockers are a 5/16”
nut driver and 2 small nail punches or drift pins for hole alignment.
The lockers should be assembled on a flat level surface and installed
in position, anchoring to the floor or wall, as required.
See the illustration to the right to identify the locker parts. Note that
the sloping hood, front base, end base, and name plate are optional
items and their assembly is covered by a separate installation
instruction.
Assembly
1. Fasten a top, bottom, and side to a back. The top and bottom are
identical parts and should have the flanges down. Insert a rear leg
and fasten. See Illustration 1.
2. Fasten another top in the center with the flanges down and the
tapered end flanges in front. See Illustration 2.
For a one-wide locker, skip to Step 4.
Illustration 1
Parts Identification
Illustration 2
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 04, 8/4/2010)

Summary of content (4 pages)