Installation Guide

Extra Wide Vented Lockers – 81000/82000/83000 Series
Installation Instructions
Thank you for selecting Salsbury’s extra wide vented single, double, or triple tier lockers. We are confident that the quality and construction of the
lockers will prove to be a good investment. These instructions are intended to assist you in assembling the lockers. The lockers should then be
placed in the installed location and anchored to the floor, wall, or to both. Individual job conditions will dictate the type of anchor fasteners.
Preliminary Notes
Please read the complete assembly instructions before attempting to
assemble the lockers. Check the materials to be sure that they are
correct for the job and that there is no damage.
The illustrations show single tier lockers, but this instruction sheet
also applies to double or triple tier lockers. Tops are installed in
between lockers with no shelves under the tops.
Be careful to use the correct hardware. Use screw no. 1 all around
with screw heads out, except where noted. Lockers should be
assembled in groups as indicated in the order of the drawings.
The essential tools required for assembling the lockers are a 5/16”
nut driver and 2 small nail punches or drift pins for hole alignment.
The lockers should be assembled on a flat level surface and installed
in position, anchoring to the floor or wall, as required.
See the illustration to the right to identify the locker parts. Note that
the sloping hood, front base, end base, and nameplate are optional
items and their assembly is covered by a separate installation
instruction. Also note that the coat rod is included with the 18” deep
single tier models only.
Assembly
1. Fasten a top, bottom, and side to a back. The top and bottom are
identical parts and should have the flanges down. Insert a rear leg
and fasten. See Illustration 1.
2. For the single tier, fasten a shelf in position under the top (see
illustrations 2 & 7). For the double or triple tier, fasten one or two
tops in the mid locations with the flanges down and the tapered end
flanges in front.
For a one-wide locker, skip to Step 4.
Illustration 1
Parts Identification
Illustration 2
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone]
Fax: [phone] Int’l Fax: [phone]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 06, 8/11/2010)