Installation Guide

Storage Lockers – 8100 Series
Single Tier Installation Instructions
Thank you for selecting Salsbury’s single tier storage lockers. We are confident that the quality and construction of the lockers will prove to be a
good investment. These instructions are intended to assist you in a single tier storage locker or a single tier storage locker with add-on units.
Individual job conditions will dictate the type of fasteners and whether the lockers must be anchored to the wall, the floor, or both.
Typical Assembly – Single Tier Starter
Typical Assembly – Single Tier Add-On
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone]
Fax: [phone] Int’l Fax: [phone]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2009 Salsbury Industries. All rights reserved. (Rev. 02, 4/8/2009)
Notes
All bolted connections should be finger tight initially. Square locker
before tightening all connections.
Adjust all doors to operate freely if required.
Instructions – Single Tier Starter
1. Set (2) two holed angle frames in vertical position as your left
front and right front frame. Attach u-channel header on corners
inside of (2) two front angle frames. Attach bolts, washers and
nuts on both corners and tighten.
2. Attach support angle bar to the bottom left and right corners
inside of front frames. Bolt and nut together and tighten.
3. Set slotted angle frame as the left rear frame and left side mesh
panel in vertical position, in line with left front frame. Attach
mesh panel to the inside top and bottom of each corner. Bolt and
nut the rest of the mesh panel and angle frame. Repeat for the
right side. Tighten bolts and nuts.
4. Attach (3) three hinges inside front left angle frame, bolt and nut
together and tighten. In upright position, set the left side of mesh
door panel to the other side of hinges. Bolt and nut together and
tighten. Attach padlock hasp and hinged anti-pry locking bar to
right front angle frame (set angle frame between padlock hasp &
locking bar). Bolt and nut together and tighten.
Instructions – Single Tier with Add-On
1. Set (2) two holed angle frames in vertical position as your left
front and right front frame. Attach u-channel header on corners
inside of (2) two front angle frames. Attach bolts, washers and
nuts on both corners and tighten.
2. Attach support angle bar to the bottom left and right corners
inside of front frames. Bolt and nut together and tighten.
3. Set slotted angle frame as the left rear frame and left side mesh
panel in vertical position, in line with left front frame. Attach
mesh panel to the inside of angle frames. Bolt and nut together
and tighten. Attach 1 round hole angle frame back-to-back to
front right angle frame as the center front frame and set center
mesh panel parallel to left mesh panel. Bolt and nut the mesh
panel to the inside of the front angle frame. Set 1 round hole
angle frame in vertical position as the right front angle and attach
u-channel header to the inside of top front center angle and top
front right angle. Attach support angle bar to the bottom front
center angle and bottom front right angle. Set 1 slotted angle
frame as the right rear frame and right side mesh panel in vertical
position, in line with right front frame. Attach mesh panel to the
inside of the angle frames. Tighten bolts and nuts. Continue
with STEP 4 (above) for both left and right units.