Installation Guide

Storage Cabinets – 9000 Series
Assembly Instructions
Thank you for selecting Salsbury’s storage cabinets. We are confident that the quality and construction of the cabinets will prove to be a
good investment. These instructions are intended to assist you in the assembly of standard, counter height, wardrobe, and combination
models. Individual job conditions will dictate whether the storage cabinets must be anchored to the wall, the floor, or both and the type
of fasteners that are to be used to do so.
General Notes
1. These instructions represent the assembly of the Salsbury standard 18” deep and 24” deep storage cabinets. Use these
instructions as a guide when assembling the combination, wardrobe and counter height models. Parts and quantities of fasteners will
differ slightly between the models.
2. All connections using screws should initially be finger tight. Square the cabinet assembly before firmly tightening all connections.
STEP 1
Locate the back panel and lay it down on a flat surface with the flanges facing up. The end with five (5) holes along the edge is the
top end. See Figure 1.
STEP 2
Locate the top panel. The panel with five (5) holes along the edge is the top panel. Place the top panel on the inside of the back panel
and align the holes. Attach top panel to back panel with screws and nuts (provided). Nuts are to be secured on the inside of the unit.
See Figure 2.
Figure 1
Top of back panel
Figure 2
Nuts are to be secured
on the inside of the unit
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes
no product assembly or installation liability. Copyright © 2015 Salsbury Industries. All rights reserved. (Rev. 04, 7/8/2015)
SALSBURY INDUSTRIES
1010 East 62nd Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone] Fax: [phone] Int’l Fax: [phone]
www.lockers.com [e-mail]
Page 1 of 5