Owner's manual

ManualsBrandsSalsbury Industries ManualsFurnitureCell Phone Locker Pedestal For Select 19000/19100 Series Surface Mounted Cell Phone Lockers

SALSBURY INDUSTRIES

1010 East 62

Street, Los Angeles, CA 90001-1598

Phone: 1-800-624-5269 Int’l Phone: 323-846-6700

Fax: 1-800-624-5299 Int’l Fax: 323-846-6800

www.lockers.com www.mailboxes.com engineering@mailboxes.com engineering@lockers.com

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

Cell Phone Locker Pedestal

For Select 19000/19100 Series Surface Mounted Cell Phone Lockers

Installation Instructions

Installing the Cell Phone Locker on the Pedestal

Step 1: Install the pedestal to the mounting surface. Use 1/2 in. diameter anchors (not provided).

Step 2: Remove the cell phone locker from the enclosure. Drill eight (8) 7/16” diameter holes through the bottom of the enclosure. Match the hole

locations on the top pedestal plate.

Step 3: Position the enclosure on the top pedestal plate then position the interior support plate inside the enclosure. Assemble to the pedestal by

installing 3/8”-16 x 1-1/2” long hex bolts (provided) through the top pedestal plate, through the bottom of the enclosure and through the interior

support plate. Fasten with 3/8” lock washers and hex nuts (provided).

Summary of content (2 pages)

PAGE 1
Cell Phone Locker Pedestal For Select 19000/19100 Series Surface Mounted Cell Phone Lockers Installation Instructions Installing the Cell Phone Locker on the Pedestal Step 1: Install the pedestal to the mounting surface. Use 1/2 in. diameter anchors (not provided). Step 2: Remove the cell phone locker from the enclosure. Drill eight (8) 7/16” diameter holes through the bottom of the enclosure. Match the hole locations on the top pedestal plate.
PAGE 2
Cell Phone Locker Pedestal For Select 19000/19100 Series Surface Mounted Cell Phone Lockers Installation Instructions Installing the Cell Phone into the Enclosure – without Front Access Panel Installing the Cell Phone into the Enclosure – with Front Access Panel Install the cell phone locker into the enclosure by sliding it into the enclosure until its front peripheral flange is flush against the front of the enclosure. Open the four corner compartments of the cell phone locker.