Installation Guide

See-Through Lockers – S-1, S-2, S-3, S-6 Series
Assembly Instructions
Thank you for selecting Salsbury’s see-through lockers. We are confident that the quality and construction of the lockers will prove to be a good
investment. These instructions are intended to assist you in assembling the lockers. The lockers should then be placed in the installed location and
anchored to the floor, wall, or to both. Individual job conditions will dictate the type of anchor fasteners.
Preliminary Note
These instructions cover assembly of four (4) different 1-wide models
varying by the number of doors (single-tier, double-tier, triple-tier, and
box style). Note that 3-wide see-through lockers are also available.
While some of the illustrations in this document show only the single-
tier locker, the assembly process should be the same for all models.
Please read the complete assembly instructions before attempting to
assemble the lockers. Check the materials to be sure that they are
correct for the job and that there is no damage.
Be careful to use the correct hardware. Use screw no. 1 all around
with screw heads out, except where noted. Screw no. 2 is for locker
legs only. Lockers should be assembled in groups as indicated in
the order of the drawings.
The essential tools required for assembling the lockers are a 5/16”
nut driver and 2 small nail punches or drift pins for hole alignment.
The lockers should be assembled on a flat level surface and installed
in position, anchoring to the floor, wall or both, as required.
See the illustration to the right to identify the locker parts. Note that
the sloping hood, front base, end base, and name plate are optional
items and assembly is covered by separate installation instructions.
Also note that the coat rod is included with the 18” deep single-tier
models only.
Assembly
1. Fasten a top, bottom, and side to a back. The top and bottom are
identical parts and should be attached with the flanges down. Insert
a rear leg and fasten. See Illustration 1.
2. Fasten the shelf in position under the top, if applicable. See
Illustration 2.
3. For a one-wide locker, skip to Step 4.
Illustration 1
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone]
Fax: [phone] Int’l Fax: [phone]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2011 Salsbury Industries. All rights reserved. (Rev. 02, 2/23/2011)
Parts Identification
Illustration 2
SHELF