Installation & Assembly

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone]
Fax: [phone] Int’l Fax: [phone]
www.lockers.com [e-mail]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2016 Salsbury Industries. All rights reserved. (Rev. 07, 02/2/2017) Page 3 of 8
Designer Locker Options
Installation Instructions
These instructions are intended to assist you in positioning and fastening the sloping hood and angled side panel to the locker.
Sloping Hood Installation Instructions
1 - Wide Sloping Hood
Place the sloping hood on top of locker with the front edge flush with
the locker body, not the door, and the sides flush with sides of the
locker. Install two (2) 1-1/4” long self-tapping dry wall screws
(provided) through the ceiling of the locker compartment (from the
inside) into the bottom of the sloping hood. Pre-drill two (2) pilot holes
(6) inches from the front face of the locker with a 1/16” drill bit as
indicated.
3 - Wide Sloping Hood
Place the sloping hood on top of locker with the front edge flush with
the locker body, not the door, and the sides flush with sides of the
locker. Install six (6) 1-1/4” long self-tapping dry wall screws (provided)
through the ceiling of the locker compartment (from the inside – two
(2) per compartment) into the bottom of the sloping hood. Pre-drill two
(2) pilot holes per compartment six (6) inches from the front face of the
locker with a 1/16” drill bit as indicated.
Angled Side Panel Installation Instructions
Attach the side panel flush with the front of the locker body, not the
door. Install two (2) 1-1/4” long self-tapping dry wall screws (provided)
in pre-drilled holes from inside the locker.