Instructions / Assembly

4
3. Material must never be left in hopper for an extended
period of time. Material will absorb moisture, bind, hard-
en and could prevent spreader from proper operation or
may damage the spreader. Empty and clean after each
use.
4. The SHPE0750 spreader is equipped with a dual independent
speed controller with warning indicators and a vibrator switch.
To start the spreader, press the ON-OFF switch. Switch will
illuminate. The auger will accelerate to full speed for 2 seconds,
then slow down to dialed speed. The spinner will accelerate to
full speed for 2 seconds, then slow down to dialed speed.
5. To activate the vibrator press the vibrator switch ON. Vibrator
switch will illuminate.
6. To stop the spreader, push ON-OFF switch to OFF position.
7. The controller will turn off after 45 minutes of inactivity.
Controller Warnings
Check controller instruction sheet for latest controller updates
and troubleshooting codes. Controller instruction sheet is inside
controller shipping box.
Thoroughly clean any tarnish or corrosion from battery
terminals.
DO NOT CONNECT WIRE HARNESS TO DAMAGED
OR CORRODED TERMINALS! IT MAY RESULT IN
OVERHEATING, LOST POWER AND POTENTIAL
CONTROLLER DAMAGE!
G. See controller instructions for latest updated and error
codes.
H. Attach utility light kit (optional) to spreader hopper in desired
location. Connect as shown in Fig. 6. Use utility light kit part
number 3018009.
Spreader Operation
1. Different materials absorb moisture at different rates and
some materials may not perform as desired. Substitution
of an alternative material may be necessary for optimum
performance.
2. When filling hopper use the supplied screen to prevent large
chunks of material and debris in the material to get into hopper
and cause damage.
Fig. 6
3014199
3006724
3035933
CB120PB
3001379
BATTERY POSITIVE
BATTERY NEGATIVE