User's Manual

ManualsBrandsSalto Systems ManualsElectronicsBLE capable wall RFID card reader

FCC Compliance Statements

(FCCID: UKCAE9, UKCAE9W, UKCL90, UKCG90, UKCRPOE, UKCNRF, UKCA9XX, UKCA9XW, UKCCLAYIQ,

UKCABXW, UKCABXX, UKCWRDBK)

This device complies with Part 15 of the FCC Rules.Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation. Changes or

modifications not expressly approved by the party responsible for compliance could void the user’s

authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions may

cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

 Consult the dealer or an experienced radio/TV technician for help.

Canadian Compliance Statement

(IC: 10088A-AE9, 10088A-AE9W, 10088A-L90, 10088A-G90, 10088A-RPOE, 10088A-NRF, 10088A-

A9XX, 10088A-A9XW, 10088A-CLAYIQ, 10088A-ABXW, 10088A-ABXX, 10088A-WRDBK)

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation. Changes

or modifications not expressly approved by the party responsible for compliance could void the user’s

authority to operate the equipment.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts

de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas

produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique

subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

Distance between 10088A-CLAYIQ and human body must be higher than 20cm. Distance entre le

10088A-CLAYIQ et le corps humain doit être supérieure à 20 cm.

EU Compliance Statement

(Products: All Salto Systems S.L. products with RFID/Wireless capability)

EN Hereby, Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain), declares

that this access control equipment is in compliance with the essential requirements and

other relevant provisions of Directive 1999/5/EC

(R&TEE). You will be able to find a copy of the original declaration of conformity at the

following Internet address:

http://www.saltosystems.com/certificate

Summary of content (4 pages)

PAGE 1
FCC Compliance Statements (FCCID: UKCAE9, UKCAE9W, UKCL90, UKCG90, UKCRPOE, UKCNRF, UKCA9XX, UKCA9XW, UKCCLAYIQ, UKCABXW, UKCABXX, UKCWRDBK) This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 2
ES Por medio de la presente Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain) declara que este equipo de control de accesos cumple con los requisitos esenciales y cualesquiera otras disposiciones aplicables o exigibles de la Directiva 1999/5/CE (R&TEE). Podrá encontrar una copia de la declaración de conformidad original en la siguiente dirección de internet: http://www.saltosystems.com/certificate FR Par la présente Salto Systems S.L. (Arkotz Kalea (Pol.
PAGE 3
DE Hiermit erklärt Salto Systems S.L. (Arkotz Kalea (Pol. Lanbarren), 9 – 20180 Oiartzun– Spain), dass sich das Gerät Zutrittskontrollgeräte in Übereinstimmung mit den grundlegenden Anforderungen und den übrigen einschlägigen Bestimmungen der Richtlinie 2004/108/EG, 2006/95/EG befindet. Eine Kopie der originalen Konformitätserklärung finden Sie auf der folgenden Internetseite: http://www.saltosystems.com/certificate NL Hierbij verklaart Salto Systems S.L. (Arkotz Kalea (Pol.
PAGE 4
modifications or product manipulations performed by anyone other than authorized SALTO dealers or personnel. Likewise, the warranty is also made null and void if the inner electromechanical structure is in any way manipulated (for instance, loosening the screws) by anyone other than SALTO personnel.