Owner manual

5
Using Your Wine Chiller
1. Place beverage container into the Body of the Wine Chiller.
2. Pour ice into the Body and around the beverage container you wish to
chill. Ice should reach up to the neck of a bottle or the top of a can.
3. Pour water into the Body and around the beverage container you
wish to chill. Water should reach up to the neck of a bottle of the top
of a can.
4. Insert Adapter into the rear of the unit (see
Figure 1.)
5. Plug Adapter into a 120V AC electrical
outlet. (Steps 4 and 5 may be skipped if
you are using the Wine Chiller’s
rechargeable battery.)
6. Set timer to chill beverage for the desired
amount of time, or turn the Control Dial to the MANUAL setting for
continuous chilling with no automatic shut-off.
CAUTION: once unit is turned on, do not attempt to remove
bottle or place hands inside of unit unless the Control Dial is in
the OF (0) position and the Agitator has come to a complete stop.
7. When the beverage is sufficiently chilled, make sure the Control
Dial is in the OFF (0) position and unplug Adapter from the wall.
Then remove the Adapter from the rear of the unit.
8. Remove beverage from Wine Chiller and serve. The Wine Chiller
may be used to store beverage in to keep beverage chilled after
opening, but once off the unit will no longer actively chill the
beverage and the beverage will begin to warm..
9. When you are done using the Wine Chiller, remove beverage
container, empty out ice and water and allow the unit to dry.
10.If you wish to chill additional beverages, for best results, repeat
steps 1 though 9.
Figure 1
Salton_WC22RE_IB_18-10-05 10/18/05 3:18 PM Page 6