variable temperature kettle 1.
IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed including the following: 1. Read all instructions. 2. Do not touch hot surfaces. Use handles or knobs. 3. To protect against electrical hazards, do not immerse cord, plugs, or the appliance in water or other liquid. 4. Close supervision is necessary when any appliance is used by or near children. Children should be supervised to ensure that they do not play with the appliance. 5.
16.Do not use Kettle without the Lid in place. 17.Scalding may occur if the Lid is opened while the Kettle is hot. SAVE THESE INSTRUCTIONS HOUSEHOLD USE ONLY GROUNDED PLUG To reduce the risk of electric shock this appliance has a grounded plug (2 blades and 1 pin). If the plug does not fit fully into the electrical outlet contact a qualified electrician. Do not modify the plug in any way or use an adaptor. BEFORE FIRST USE 1. Read all instructions carefully and keep them for future reference. 2.
3. Close the Lid. Ensure that it snaps tightly into place. 4. Place Kettle and Base on a flat, level, dry, heat resistant surface. Ensure that it is correctly engaged on the Base. 5. Plug into a 120V AC wall outlet. NOTE: Never plug kettle into an electrical outlet when the kettle is empty. 6. Direct kettle spout away from cabinets, walls, etc. to prevent possible steam damage. 7. The default temperature is 100°C (212°F).
15.IMPORTANT: If the Kettle is accidently switched on when empty, the thermostat will automatically cycle on and off to prevent the Kettle from overheating. If this situation occurs unplug the Kettle immediately and allow the Kettle to cool before refilling. 16.It is recommended that the Power Cord be disconnected from the wall outlet when not in use. 17.DO NOT attempt to connect any other appliance to the Power Base or tamper with the connector in any way.
Exterior - Use a soft, damp cloth to clean the exterior. - DO NOT use abrasive cleaners. Dry exterior thoroughly before use. - DO NOT immerse kettle or power base in water or other liquid. 1. Filter The Aquascreen® filter is in 2 parts. The filter holder is permanently installed inside the kettle. The removable portion, which includes the mesh, can be slid in and out along the 2 grooves on either side of the filter holder. Wash the filter in warm soapy water. Rinse and replace in the filter holder. 2.
TO OBTAIN PROMPT WARRANTY SERVICE: Contact one of our many Service Centers found on our website www.salton.com/customer-care or Securely package and return the appliance to us. Please enclose: • Original proof of purchase • The completed form below with a $12.