User's Manual

AKL04PRF Zone Pump Wiring Center
Wiring Guide
AUX XX ZONE1 E/S
TRANSFORMER
L N
GROUND
L N
PUMP2
L N
PUMP3
L N
PUMP4
L N
PRIMARY
PUMP
L N
120 VAC
OUTPUT
MASTER
PRIORITY ON
EXERCISE ON
PRIMARY STATUS DURING PRIORITY ON
PURGE ON
SLAVE
OFF
OFF
OFF
OFF
Group 1 thermostats
G1 (1-2)
120 VAC
120VAC TO PUMP Cables will
be supplied by the installer.
H N
H N
R W C
C1 C2
COMMS
BOILER
FUSE 5A
SLOW BLOW
FUSE 5A
SLOW BLOW
FUSE 5A
SLOW BLOW
FUSE 5A
SLOW BLOW
FUSE 5A
SLOW BLOW
POWER IN GROUND
PRIORITY
PUMP1
Group 2 thermostats
G2 (3-4)
ZC N
GND
24V-T-STAT 1
R CW
Domestic Hot Water/Zone
24VAC thermostat
Group 1 thermostats
G1 (1-2)
Group 2 thermostats
G2 (3-4)
120VAC TO PUMP
(Cables to be supplied by installer)
WIRED WIRELESS
External Antenna
INT EXT
Antenna Selection
24VAC Thermostat Connections
R / H 24VAC
W / Call for Heat
C / N 24VAC common
Dry Contacts (rated 120VAC, max.2A)
AUX Auxiliary
XX Active Pump(s)
Zone1 E/S Local Priority
Master/Slave Communication Lines (5V)
C1 Master Priority
C2 Slave Active
GND Communication Ground
120VAC Connections
L
AC Line In (max. 20A)
Zone Pump Line Out (max. 1/6 HP)
N AC Neutral
ZC Zone control/Priority Input(120VAC)
Earth Ground
Fuse: 5A slow blow, 5x15mm (2AG)
BOILER
Electrical Connections
FCC/IC Statements and Notices
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation. This equipment
has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC and Industry Canada
RF Radiation Exposure statement: This equipment complies with FCC and Industry Canada RF radiation exposure
limits set forth for an uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 20 centimeters between the antenna and all persons.
Cet appareil est conforme aux limites d’exposition au rayonnement FR du FCC et d’Industrie Canada pour un
environnement non contrôlé. Cet appareil devrait être installé et devrait fonctionner de sorte qu’il se trouve à
une distance d’au moins 20 cm entre l’antenne et toute personne.
Industry Canada
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : 1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
Issue Date: Apr 2017
For PDF Installation guide go to
www.salusinc.com
Technical Helpline 1-855-557-2587
Warning
This product must be installed by qualified
personnel and the installation must comply
with the codes and regulations applicable to
the municipality where this product is installed.
Failure to do so could lead to injury, death, or
prosecution.
Always disconnect the AC power before
installing or working on AC power components.
AUX XX ZONE1 E/S
TRANSFORMER
L N
GROUND
L N
PUMP2
L N
PUMP3
L N
PUMP4
L N
PUMP5
L N
PUMP6
L N
PRIMARY
PUMP
L N
120 VAC
OUTPUT
24V - T-STAT 1
120 VAC
120VAC TO PUMP Cables will
be supplied by the installer.
H N
H N
R W C
C1 C2
COMMS
BOILER
FUSE 5A
SLOW BLOW
FUSE 5A
SLOW BLOW
FUSE 5A
SL
OW BLO
W
FUSE 5A
SLOW BLOW
FUSE 5A
S
L
OW BLO
W
FUSE 5A
SLOW BLOW
FUSE 5A
SLOW BLOW
POWER IN GROUND
PRIORITY
PUMP1
ZC/ZR
Group 1 thermostats
G1 (1-2)
Group 2 thermostats
G2 (3-6)
AHTR5024
AHTR3024
AHTR3024
AHTR3024 AHTR3024 AHTR3024
MASTER
PRIORITY ON
EXERCISE ON
PRIMARY STATUS DURING PRIORITY ON
PURGE ON
SLAVE
OFF
OFF
OFF
OFF
Wired Wireless
Antenna Selection
INT EXT
POWER
PRIORITY
ZONE 1
ZONE 2
ZONE 3
ZONE 4
ZONE 6
G1
G2
Network Status
•
•