08/2020 Electronic Room Thermostat 2 Instruction Manual Model No RT100
08/2020 2 RT100 INSTRUCTION MANUAL
08/2020 PRODUCT COMPLIANCE This product complies with the essential requirements of the following EC Directives: • • • Electro-Magnetic Compatibility directive 2004/108/EC Low Voltage Directive 2006/95/EEC EC Marking directive 93/68/EEC SAFETY INFORMATION These instructions are applicable to the Salus Controls model stated on the front cover of this manual only, and must not be used with any other make or model.
08/2020 INTRODUCTION A thermostat is a device that is used to switch the heating system in your home on and off as needed. It works by sensing the air temperature and switching on the heating when the air temperature falls below the thermostat setting, and switching it off once the set temperature has been reached. The RT100 from Salus Controls is a stylish and accurate mechanical thermostat with a large, easy to adjust setting dial. The thermostat has been specifically designed to be used Volt Free.
08/2020 INSTALLATION Please read the important safety information at the start of this manual before you begin to install the thermostat. Location The ideal position to locate the RT100 thermostat is about 1.5m above floor level, in a location where the thermostat is accessible, reasonably lit and free from extremes of temperature and draughts. Do not mount the thermostat on an outside wall, above a radiator or in a location where it may be subjected to direct sunlight.
08/2020 ELECTRICAL CONNECTIONS Terminal Description N Mains Neutral L Mains Live COM Common NO Normally Open Contact NC Normally Closed Contact NO contact is used for heating; NC contact for cooling Wiring Diagram Do not restore the mains supply to the system until all associated items are fully installed. NOTE: All electrical installation work should be carried out by a suitably qualified Electrician or other competent person.
08/2020 REASSEMBLING THE THERMOSTAT Reassembly of the RT100 is very straightforward; just a reversal of the steps taken earlier. Refit the cover and secure with the securing screw, and refit the setting dial: do not force the dial - it will only locate in one position. Do not remove or refit the cover of the RT100 without the mains supply to the system being isolated.
08/2020 ENERGY TIP One way to set and use your room thermostat is to find the lowest temperature setting that you are comfortable with, and then leave it set at this temperature.
08/2020 PRODUCT SPECIFICATION Model: Type: RT100 Surface mounted mechanical room thermostat designed for volt free heating applications. heating applications. Switching Switching Voltage: Switching Current: Contact Type: 230V AC / 50Hz 1A inductive Volt Free Temperature Range: Differential: 5 ºC to 35 ºC 0.5ºC to 0.
08/2020 RT100 Warranty Salus Controls warrants that this product will be free from any defect in materials or workmanship, and shall perform in accordance with its specification, for a period of two years from the date of purchase. Salus Controls sole liability for breach of this warranty will be (at its option) to repair or replace the defective product. Customer Name: .............................................................. Customer Address: ........................................................
08/2020 RT100 INSTRUCTION MANUAL 9
08/2020 salus-tech. Sales: Email: sales@salus-tech.com Tel: 01226 323961 Technical: Email: tech@salus-tech.
