User's Manual

13 | P a g e
5.2 Installing FOBO Tire In-car unit & sensors
NOTE: DO NOT INSTALL THE SENSORS TO THE CAR TIRE VALVES
UNTIL INSTRUCTED BY THE FOBO TIRE APP INSTRUCTION
NOTE: INSTALLING FOBO TIRE SETS ON MORE THAN ONE CAR
WHICH ARE PARKED CLOSELY TOGETHER MAY CAUSE CROSS
INTERFERENCE TO THE BLUETOOTH SIGNALS. PLEASE INSTALL
FOBO TIRE ON ONE CAR AT A TIME.
Remove the battery tab from In-car unit battery compartment before proceeding for
installation. In-car unit will be powered on immediately as soon as the battery tab is
removed. Follow the below steps from the FOBO Tire app:
1) Click “+” on the app HOME screen to add a car to your profile.
2) Key in the name you would like to identify your car with and take the picture.
3) Select the car manufacturer recommended pressure for both front and rear tires.
The information is usually available on a sticker at the door jam (side of the
driver’s door) or in the owner’s manual. For some car models, the information
sticker may be on the trunk lid or on the fuel door. The app will not work
without this information.
4) Click “Done” on the top right hand corner of the screen.
5) Next, you will be prompted to install the tire sensors. Screw in the FOBO Tire
sensor to your Front-Right tire. Make sure your smart phone is nearby or
touching the sensor to detect signal from the sensor unit. Repeat with Rear-
Right, Rear-Left and Front-Left tires. You will be prompted that installation is
completed and you are now ready to use FOBO Tire.