User's Manual

15 | P a g e
5.4 Tire rotation
It is good practice to rotate your tire positions regularly to balance the thread wear
of your tires. Once tire position is changed, please select Tire Rotation in car status
screen. You will be guided by the app to:
1) move to the front right tire of your car
2) place your phone close to the sensor and hold for 15 seconds. For faster
response, you can also unscrew the sensor fully from the tire and screw it
back.
3) repeat step 1 & 2 for rear right, rear left and front left tires.
4) Tire rotation is complete
You are now ready to use FOBO Tire with the new tire positions. You can perform
tire rotation as often as you want.
5.5 Disable sensor and Replace new sensor
You may want to disable a sensor due to sensor missing or sensor damaged.
Disabling sensor will remove future missing sensor alerts. To disable sensor, long
press for 5 seconds on the box corresponding to the tire position you want to disable.
Click OK on the message box to disable the sensor. You will see “Disabled” inside
the box corresponding to the disabled tire position. Take note that FOBO Tire will
stop monitoring tire for a disabled sensor position.
In case the lost sensor is found or you have purchased a new replacement sensor,
you may want to install onto the “Disabled” tire position. Note that you can only
install replacement sensor after the tire position has been “Disabled”. To install
replacement sensor, long press for 5 seconds on the box corresponding to the
“Disabled” tire position. You will get a message prompting you to screw in the
sensor to the indicated tire position. Click OK on the message box to begin
installation procedure. Once the sensor is paired, you will get tire pressure reading
on the screen.
5.6 Transfer FOBO Tire to another user
Before passing on your FOBO Tire set to another user, you will have to release the
In-Car unit from your login account. Select “Release In-Car unit” in car setting screen.
Make sure your In-Car unit is with you. You will be prompted with a message to
press and hold the button at the side of In-Car unit until you hear a “Beep” sound and
the car profile from your “Home” page is erased. Your FOBO Tire set is now
available for the other user to pair and use.