User Manual

Go Mic Mobile

Getting Started - Audio Connections

The Go Mic Mobile can be connected to a smartphone using the Micro USB digital

output or 3.5mm analog output.

Connecting to an iOS device (iPhone, iPad or iPod Touch)

Using the included Micro USB to Lightning cable, connect the cable to the USB

Audio Output jack on the GMM to the Lightning connector on the iOS device. Once

connected, the iOS device will recognize the Go Mic Mobile as the audio input

device.

Open a recording or video application and start recording.

Note: It is recommended to put your iOS device in Do Not Disturb mode or Airplane

mode to eliminate the video or audio recording from being interrupted by a phone

call. Leave Airplane Mode off to keep geolocation information tagged to your video

ﬁles.

Connecting to an Android device with the digital audio output

The Go Mic Mobile will work with Android device running Android 5.0 or later and

have an app that supports USB Audio. To connect using the USB Audio Output

jack, make sure your Android device can accept a digital audio input. Using the

Micro USB to USB type-C or Micro USB to Micro USB cable, connect the cable to

the Micro USB audio output on the GMM and the USB input of the Android mobile

device.

Connecting to a mobile device with the analog audio output

If your mobile device does not accept digital audio input, the GMM can be connected

using the 3.5mm analog output. When connecting to a smartphone, you will need

to set the Analog Output Select Switcb switch to either the Out 1 or Out 2 position.

For most smartphones the Out 1 (CTIA / AHJ) position is the appropriate setting. If

your mobile device uses OMTP wiring for the input, use the Out 2 position. For more

information on smartphone wiring visit www.samsontech.com/support/go-mic-mobile

Connecting to a DSLR, cinema camera, or mixer

When connecting the GMM to a DSLR camera, cinema camera or mixer, use the

included 3.5mm analog audio output. Set the Output Selector switch to the Line/

Headphone setting.

Monitoring with the Go Mic Mobile

The GMM 3.5mm output can be used to monitor the audio transmitted to the

receiver. The headphone output follows the MIX / 2 CH Switch. The level of the

headphones is controlled by the VOL output slider and follows the output level of the

USB Audio Output.