User's Manual
Table Of Contents
- General Safety Precautions
- List of Contents
- 1 Overview
- 2 Basic Settings; General Remarks about Operating
- 3 PPI Settings
- 3.1 Screen Stabilisation of the PPI: True Motion, Relative Motion
- 3.2 PPI Orientation: Head-Up, North-Up, Course-Up
- 3.3 Centering / Off-Centering of the Display (Center, Off-Center)
- 3.4 Range Selection (Range)
- 3.5 Range Rings, Grid
- 3.6 Own Ship Symbols and Target Symbols, Vectors, Past Position Plots
- 3.7 Trails
- 3.8 Setting the Display of Pre-planned Tracks
- 3.9 Defining the System Track and the Next Waypoint; System Track Display
- 3.10 Setting the Display of User Chart Objects on the RADARPILOT
- 3.11 Setting the Display of Charts and User Chart Objects on the CHARTRADAR
- 3.12 Setting the Display of the Map
- 3.13 Adjusting the Chart or Map to the Radar Video
- 4 Setting the Radar Function
- 4.1 Radar Function On/Off, Interswitch Functions, Master/Slave Switch-Over
- 4.2 Basic Setting of the Radar Video
- 4.3 Selection of the Antenna Revolution Rate
- 4.4 Radar Setting for High Speed of Own Vessel (HSC)
- 4.5 Radar Setting for the Display of RACON Codes
- 4.6 Radar Setting for SART Detection (X-Band only)
- 4.7 Suppression of the Synthetics and Video
- 5 Heading, Speed, Position
- 6 Bearing and Range
- 7 ARPA Functions
- 7.1 Symbols Used
- 7.2 Procedure of the Target Acquisition
- 7.3 Manual Target Acquisition
- 7.4 Automatic Target Acquisition; Settings of the Acquisition/Guard Zone
- 7.5 Deletion of Targets, Loss of Target
- 7.6 Target Data Display
- 7.7 Target Labels
- 7.8 Selecting the Reference Targets for Reference Target Tracking
- 8 EPA Functions (Electronic Plotting Aid)
- 9 Collision Avoidance (TCPA, CPA)
- 10 Trial Manoeuvres
- 11 Editing of Pre-planned Tracks
- 12 Editing the Map
- 13 Displays in the Multidisplay
- 14 Quick Info Box
- 15 Evaluation of the Radar Video
- 16 The Radar Keyboard
- 17 Alarm Management
- 18 List of Alarms
- 19 List of the Alarm Signal Outputs
- 20 Care and Maintenance Work
- 21 Performance Monitor
- 22 System Maintenance Manager
- 22.1 Determining the Versions of Software, Hardware and Documentation
- 22.2 Listing the System Faults
- 22.3 Off-Line Selfcheck
- 22.4 Checking / Correcting the Computer Time
- 22.5 Distribution and Deletion of Map Data; Data Saving
- 22.6 Exchanging Track Files between the Indicators; Data Saving
- 22.7 The Handling of Diskettes
- 22.8 Aborting and Restarting the Program of the Radar System
ED 3038 G 232 / 01 (2002-06)
Operating Instructions
20 Care and Maintenance Work
20.1 Care
b_r1_e71.fm / 21.06.02
129
RADARPILOT / CHARTRADAR
20 Care and Maintenance Work
Subjects of this Section:
◆ Care of the system’s components
◆ Routine maintenance work
20.1 Care
Care of the components of the radar system is limited to occasional cleaning of the screens on the moni-
tors. This should be done with a soft cloth moistened with alcohol.
20.2 Maintenance Work
The ship’s personnel must regularly carry out the following maintenance work:
The cleaning of the filter pad on the Display Electronics Unit and on the TRACKPILOT Electronics
Unit.
If conditions are normal, this work should be done once every 3 months. If the environment is particularly
dusty, it should be done more frequently, and if the air contains very little dust, it can be done less
frequently.
1. Taking out the filter pad: It is situated on the top of the display electronics unit, and can be gripped
and pulled out by its front left-hand corner without unscrewing the covering cap.
☞ If the display electronics unit is installed in the console, the hinged cover situated below the
operating unit must first be opened.
2. Cleaning the filter pad: Cleaning can be done by washing in soapy water, or by blowing the dust
out with compressed air, or - depending on the degree of dirtiness - simply by beating the dust out.
3. Inserting the filter pad: When inserting the filter pad, which must have been dried (if necessary, by
jolting it thoroughly to get the water out of it), make certain that it is seated properly.
Test of the Transmission Power and Receiver Sensitivity of the Radar Transceiver
The test described in Section 21 should be performed at the beginning of every sea voyage, and once a
week during the voyage.