Operation and programming manual

ER-260/265 Electronic Cash Register AU Program Mode Programming • 69

System Option Programming

Twenty system options are provided so that you can configure the SAM4s ER-260/265 to your exact

requirements. Refer to the “System Option Table” to review the system options. Read each option

carefully to determine if you wish to make any changes.

NOTE: Because after clearing memory all options settings are automatically set to 0, and

because your most likely option selections require a status setting of 0, you do not need

to program this section unless you wish to change the default status.

Programming a System Option:

1. Turn the control lock to the PGM position.

2. Enter the option number of the system option you wish to change.

3. Press the RA key.

4. Enter the number representing the status you have selected.

5. Press the PO key.

6. Repeat step 2 to 5 for each system option you wish to change.

7. Press the CASH/TEND key to end programming.

System Option Flowchart

PO RA

Status

CASH/

TEND

Repeat for each

stem O

tion

Option #

System Option Programming Examples

Set the following options

• Option 15: Allow check cashing.

• Option 20: Enforce cash or check tender at totaling.

To set option 16:

PO RA 1 5 1

To set option 20:

PO 1 0 2 RA

Press the CASH/TEND key to end programming.

CASH/

TEND