User Manual

Installation/Removal of the Battery

1. Installation of the Battery

Please make sure the transceiver is powered off, and then hold down the belt clip to open it ,

Hold down the two side keys and insert the two bumps on the top of the battery into

the aluminum grooves of the transceiver in the direction of the arrow, and to finish the installation,

press the bottom of the battery in the direction of the arrow until the “ka-ta” sound is heard.

Note: If the battery is not fixed well, please remove it and reinstall.

2. Removal of the battery

To remove the battery, please make sure the transceiver is powered off,

and then press and hold to open the belt clip so that the open the belt clip so that the

open the belt clip so that the

battery can get out when the

button has been turned upward.

Pull the battery out according to the

arrow after the battery hook is detached.

Installation /Removal of Antenna

1. Installation of the antenna

⑴

Plug the screw-thread end of the antenna into the socket at the top of the transceiver.

⑵

Rotate the antenna clockwise until tightening up , as shown.

2. Removal of the antenna

Rotate the antenna counterclockwise to remove it.

Installation /Removal of Belt clip

1.Installation of the belt clip

First remove the battery, and then place the clip on the rear top of the

machine, and fix it with two screws by a cross-screw.

Note: Do not install the belt clip unless the battery is off.