Manual

8 | SAMLEX AMERICA INC.

SECTION 3 | Installation

Figure 3-1 Mounting & Cooling



Use a pencil or pen to mark the four (4) mounting hole locations on the mounting

surface.



Remove the controller and drill 4.5Mm holes in the marked locations.



Place the controller on the surface and align the mounting holes with the drilled holes

in step 4. Secure the controller in place using the mounting screws.

WIRING

INFO

• Arecommendedconnectionsequencehasbeenprovidedbelowfor

maximum safety during installation.

• ThecontrollerisacommonPositivegroundcontroller.

CAUTION!

 

EXCEEDING 10A.

 

Warm Air

Cool Air

150 mm / 5.9"