User Manual

MiniStation All-in-One Petit Board User’s Manual
Award BIOS Setup
58
other devices still operate at full speed. The default value is “Disabled”.
Disabled
System will never enter doze mode
1/2/4/6/8/10/20/30/40
Min/1 Hr
Defines the continuous idle time
before the system entering DOZE
mode.
z Standby Mode
After the selected period of system inactivity (1 minute to 1 hour), the fixed disk drive and the video shut off while
all other devices still operate at full speed. The default value is “Disabled”.
Disabled
System will never enter STANDBY
mode
1/2/4/6/8/10/20/30/40 Min/1
Hr
Defines the continuous idle time
before the system entering
STANDBY mode.
If any item defined in (J) is
enabled & active, STANDBY timer
will be reloaded
z Suspend Mode
After the selected period of system inactivity (1 minute to 1 hour), all devices except the CPU shut off. The
default value is “Disabled”.
Disabled
System will never enter SUSPEND
mode
1/2/4/6/8/10/20/30/40
Min/1 Hr
Defines the continuous idle time
before the system entering
SUSPEND mode.
If any item defined in (J) is enabled
& active, SUSPEND timer will be
reloaded
z HDD Power Down
After the selected period of drive inactivity (1 to 15 minutes), the hard disk drive powers down while all other
devices remain active. The default value is “Disabled”.
Disabled
HDD’s motor will not power OFF.
1/2/3/4/5/6/7/8/9/10/
11/12/13/14/15 Min
Defines the continuous HDD idle time
before the HDD enters power saving
mode (motor OFF)
z Throttle Duty Cycle
When the system enters Doze mode, the CPU clock runs only part of the time. You may select the percent of time
that the clock runs. The default value is “62.5%”.
z PCI/VGA Act-Monitor
When Enabled, any video activity restarts the global timer for Standby mode. The default value is “Enabled”.
z Soft-Off by PWR-BTTN
This option only works with systems using an ATX power supply. It also allows the user to define which type of
soft power OFF sequence the system will follow. The default value is “Instant-Off”.
Instant-Off
This option follows the conventional manner
systems perform when power is turned OFF.
Instant-Off is a soft power OFF sequence
requiring only the switching of the power supply
button to OFF
Delay 4 Sec.
Upon turning OFF system from the power switch,
this option will delay the complete system power
OFF sequence by approximately 4 seconds.