User Manual

MiniStation All-in-One Petit Board User’s Manual

Award BIOS Setup

z Parallel Port Mode

Select an operating mode for the onboard parallel (printer) port. Select Normal unless your hardware and

software require one of the other modes offered in this field. The default value is “ECP+EPP”.

NOTE: Selecting EPP on this option will allow selection to the EPP Mode (EPP1.7, EPP1.9)

ECP mode selection will provide option for ECP Mode Use DMA.

Choosing ECP+EPP modes will provide selections for both EPP Mode Select and ECP Mode Use

DMA.

z ECP Mode Use DMA

Select a DMA channel for the port.

z EPP Mode Select

Select EPP port type 1.7 or 1.9.

5.13 Supervisor/User Password Setting

You can set either supervisor or user password, or both of then. The differences between are:

1. supervisor password: can enter and change the options of the setup menus.

2. user password: just can enter but do not have the right to change the options of the setup menus.

When you select this function, the following message will appear at the center of the screen to assist you

in creating a password.

ENTER PASSWORD:

Type the password with eight characters at most, and press <Enter>. The password typed will now clear

any previously entered password from CMOS memory. You will be asked to confirm the password. Type

the password again and press <Enter>. You may also press <Esc> to abort the selection and not enter a

password.