User Manual

MiniStation All-in-One Petit Board User’s Manual

Award BIOS Setup

z IDE Primary/Secondary Master/Slave UDMA

Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the operating environment

includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus master driver). If your hard drive and your

system software both support Ultra DMA/33, select Auto to enable BIOS support. The default value is “Auto”.

z On-Chip Primary/Secondary PCI IDE

The integrated peripheral controller contains an IDE interface with support for two IDE channels. Select Enabled

to activate each channel separately. The default value is “Enabled”.

NOTE: Choosing Disabled for these options will automatically remove the IDE Primary Master/Slave PIO

and/or IDE Secondary Master/Slave PIO items on the menu.

z USB Keyboard Support

Select Enabled if your system contains a USB controller and you have a USB keyboard. The default value is

“Disabled”.

z Init Display First

This item allows you to decide to active whether PCI/ISA or Onboard first. The options available are PCI/ISA, and

Onboard.

z POWER ON Function

This option allows users to select the type of power ON sequence for the system to follow. The default value is

“Button-Only”.

BUTTON-

ONLY

Follows the conventional way of turning OFF system power

(via power button).

Password

Upon selecting this option, the KB POWER ON Password line

appears. Press <Enter> and you’ll be prompted to enter and

confirm a password of your choice.

After setting the password, succeeding attempts to power ON

the system will result to null. For system to activate, user must

input the password via keyboard then press <Enter>.

Hot KEY

This option is very similar with that of Password. Hot-key

combinations range from Ctrl-F1 to Ctrl-F12. User may define

this combination from the Hot key Power ON option.

Continued . . . . .