User Manual

MiniStation All-in-One Petit Board User’s Manual
PCMCIA Card
80
7.2.2 Installation for DOS & Windows 3.1X:
During the installation procedure, if one of the following memory managers is defected. a warning screen
similar to the one shown below is displayed. and the appropriate DEVICE line changes prompt for your
memory manager are also shown on the screen
EMM386 QEMM 386MAX
The CardSoft 3.1 Install Utility has detected the presence of the
ENN386 memory manager. In order for CardSoft 3.1 to
function properly, the certain ranges of memory need to be excluded
from this memory manager. If you wish to ensure proper functionality
of the CardSort 3.1 drives we suggest you to add the switch
x=D000-DFFF. After this installation is complete, please edit
the lines in your CONFIG.SYS file to appear as below
DEVICE=C:\DOS\EMM386.EXE NOEMS X=D000-DFFF
Press [Exc] to quit, any other key to continue…………..
If you see the screen (or a similar screen). write town the displayed DEVICE line. When the installation has
completed, change the memory device line in your CONFIG.SYS file to match the one displayed on this
screen. To edit or display your CONFIG.SYS file, type command Edit config-sys at the DOS prompt. If
you are using the EMM386 memory manager. look for a line similar to the following (If you don not see a
line like this. then you are not using EMM386 on your system)
device=emm386.exe
To exclude the address range D000-DFFF change this line as shown here (this is what is displayed on the
installation screen if EMM386 is defected)
device=emm386.exe noems x=d000-dfff
If you are using a memory manager other than those listed, refer to the manual that you received with the
memory manager for instructions on how to exclude an address range. The installation procedure are
following.
1. Start you computer. Insert the CardSort & CardView diskette into drive A: or B:
2. If you are a Windows 3.1 user, start up Windows now. From the Program Manager, select File, the
Run, and type in A:\INSTALL or B:\INSTALL when asked for a filename and press Enter. If you are
a DOS user, type A:\INSTALL or B:\INSTALL from the DOS prompt and press Enter.
3. Following the instructions that appear on your screen. If you have problems or questions, refer to
the CardSoft User’s Guide in the supplied diskette for help.
4. If you are a Windows user, you’ll probably want to install CardView after the CardSoft installation
is complete. To install CardView, start up Windows, from the Program Manager, select File, then
Run, and type A:\SETUP or B:\SETUP when asked for a filename. When the CardView program