0 WATT GUITAR COMBO
Caution: To reduce the hazard of electrical shock, do not remove cover or back. No user serviceable parts inside. Please refer all servicing to qualified personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture.
Table of Contents Introduction...........................................................................................................2 Hartke G10 Guitar Amplifier Features...........................................................3 Guided Tour - Front Panel..................................................................................4 Setting Up and Using Your Hartke G10 Guitar Amplifier.......................5 G10 Sample Settings......................................................................
Introduction We know you don’t like reading owners manuals, but you’ve just purchased one of the finest guitar amplifiers around, and we want to tell you about it! So, before you plug in and start strumming and shredding, we’d like to suggest you take just a few moments to scan these pages. We’ll make it as painless as possible, we promise—and, who knows, you might just pick up a tip or two.
Hartke G10 Guitar Amplifier Features The Hartke G10 amplifier has been designed for modern guitar players looking for a new sound that respects the tone of a classic amp. Here are some of its main features: • Ample power, the G10 combo offers a 10-Watts of shredding power. • CRUNCH control for 2-channel selection built around a Hartke burn'in-hot G Series pre-amp. • The G10 combo features an 6.5-inch, custom designed Hartke GXL speaker installed in an enclosure with open-back configuration.
Guided Tour - Front Panel 1 INPUT - Connect your guitar to this standard 1/4” unbalanced jack. This G Series Input was designed to handle the signals from a guitar with a wide range of output levels from lipstick single coils to the beefiest humbucker. 2 CHANNEL switch - The switch allows you to select either CHANNEL 1 or CHANNEL 2.
Setting Up and UsingYour Hartke G10 Guitar Amplifier 1. Remove all packing materials (save them in case of need for future service) and decide where the amplifier is to be physically placed. To avoid potential overheating problems, make sure that the rear panel is unobstructed and that there is good ventilation around the entire unit. 2. Before you plug-in the power cable, be sure the POWER switch is in the off (down) position. Then, plug-in the 3-pin AC plug into any grounded AC socket.
Using Your Hartke G10 Guitar Amplifier 8. Next, adjust the BASS and TREBLE equalizer controls to taste. (When you get a great setting that complement your instrument and playing style, it’s a good idea to write it down for future use.) 9. Now, let's get a burnin overdrive tone. First, turn the VOLUME KNOB to 0 (fully counterclockwise) and press the CRUNCH SWITCH to the in position. 10.
G10 Sample Settings The G Series combos are powerful amps with a lot of personality. The amplifiers offer guitarist a wide range of sounds and after playing just a short time; you’ll find the tone that's perfectly suited for your playing style and your sound. To get you started, try some of the samples settings below. Remember, different guitars are made of different wood and have different pick-ups, so the sound will vary a little bit on each individual set up.
G10 Setting Templates
Specifications Rated Output Power Input Impedance Headphone Output Connector Fuse Rating US & Japan UK & European Weight Dimensions 10 w 1M OHM 200 mW (typical) @ 600 ohms 1/4-inch Phone Jack 1A 2A 8.8 lbs. (3.99 kg) 12.05” (306 mm) H x 10.75” (273 mm) W x 6.
Hartke 45 Gilpin Avenue Hauppauge, New York 11788-8816 Phone: 1-800-3-SAMSON (1-800-372-6766) Fax: 631-784-2201 www.hartke.
